Electrician checking a socket in a freshly plastered room

Round-the-Clock Call Out Electricians

Home Rewiring in Guildford

Tired or damaged wiring lies behind plenty of the emergencies we attend. Once it can't be repaired, we replace it, whether that's one circuit or the entire property.

  • Whole-house and partial rewires
  • Rewiring after fire, flood or a failed EICR
  • Every job tested and certified at the end
  • Prices made clear before work begins
Call 01483 000000

When to act

Signs it may be time for a rewire

Wiring has a limited lifespan. Here are the reasons we most often advise replacing it.

Outdated cable types

Rubber, fabric-covered or lead-sheathed cables have long outlived their safe working life.

Heat and scorch marks

Browned sockets, a smell of burning or warm switch plates can all signal worn-out wiring.

Repeated tripping

A circuit that trips again and again, with no one appliance to blame, often has insulation that's breaking down.

Damage from fire or flooding

Cabling that has been in a fire or underwater generally can't be relied on and should be replaced.

An unsatisfactory EICR

Where your report flags dangerous or potentially dangerous wiring, rewiring may be the answer.

Building work and extensions

With walls and floors already open, it's the ideal moment to modernise the wiring.

Call 01483 000000Open 24/7 • With you in 30 to 90 minutes

The fault explained

Rewiring explained

Every installation has a working life. When it runs out, or the damage can't be repaired, replacement is the only safe route. Here's how to spot it and what the work involves.

What's happening

Most modern cable has PVC insulation and, if fitted correctly, will last for decades. Older homes can still contain rubber-insulated, fabric-covered or lead-sheathed cable, which turns brittle over time and may crumble when disturbed. PVC cable isn't immune either: heat, rodents, water and poor workmanship can all damage it.

Rewiring doesn't have to cover the entire house. Where one or two circuits have failed or been damaged, replacing just those in a partial rewire may be enough. Testing shows us which applies.

Usual culprits

  • AgeingOver the years rubber and fabric insulation deteriorates, exposing the conductors inside walls and floors.
  • Heat-related damageCables that run through hot spaces, sit under insulation or carry too much load can soften and break down.
  • Fire and floodingWiring that has met fire, smoke or flood water generally can't be trusted afterwards.
  • Rodent damageGnawed cables in lofts and beneath floors can compromise entire runs of wiring.
  • Substandard alterationsYears of DIY additions and extensions can leave a circuit unsafe and beyond proper repair.
  • An unsatisfactory EICRPoor insulation resistance on many circuits frequently shows the wiring has come to the end of its life.

How we put it right

First comes a survey, where we inspect and test the existing installation to decide what can stay and what must go. You receive a written quote and a plan for the work. In a full rewire, new cables go in while floors and walls are open (the first fix), after which sockets, switches, fittings and usually a new consumer unit are fitted (the second fix).

Wherever we can, we go room by room so the house remains usable, and we switch power back on at the end of each day where possible. Once everything is in place, each circuit is tested and you receive the certificate for the work. We make good as needed and leave the property tidy.

Call 01483 000000Seen any of these signs? Ring us right away.

The process

How a rewire works

Rewiring is a major job, so we plan it carefully to keep disruption as low as possible.

  1. Survey

    We inspect and test the installation, then tell you whether you need a full or a partial rewire.

  2. Quote

    You receive a clear written price along with a room-by-room plan for the work.

  3. First fix

    New cables are run while floors and walls are open. We keep as much of the house in use as we can.

  4. Second fix and test

    Sockets, switches and fittings are fitted, then everything is tested and certified.

Call 01483 000000Open 24/7 • With you in 30 to 90 minutes

Need an electrician urgently?

Expect us within 30 to 90 minutes, day or night.

Call 01483 000000

About rewires

Rewiring for houses across Guildford

A rewire, house rewire or rewiring job involves replacing the electrical cabling in a property, either throughout (a full rewire) or only on the circuits that need it (a partial rewire). It's typically required for ageing wiring, following fire or flood damage, or when an EICR concludes the wiring is unsafe.

We handle full and partial rewires in Guildford's cottages, townhouses and newer homes, along with rewiring for renovations and extensions. Each rewire is tested and certified when finished, and a new consumer unit can be included at the same time.

Looking for a rewiring electrician in Guildford, Woking, Godalming or Farnham, or need old wiring replaced after an electrical emergency? Call us for a survey and a clear quote.

Call 01483 000000Open 24/7 • With you in 30 to 90 minutes

FAQs

Common questions

How long will a rewire take?

That depends on the property's size. A typical home takes several days, and we'll give you a timescale alongside the quote.

Can I stay in the house while it's rewired?

Generally, yes. We go room by room and bring the power back on at the end of each day wherever we can.

Is it possible to rewire only part of the house?

Yes. If just some circuits are faulty or outdated, a partial rewire could be all that's required.

Will it be messy?

A little, since cables have to go into walls and under floors. We keep things tidy and make good where the work requires.

Call 01483 000000Haven't found your answer? Ring us, day or night.